The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

ZDP200 HomePro ZDP200 Wall Dimmer

This describes the Z-Wave device ZDP200, manufactured by ACT - Advanced Control Technologies with the thing type UID of act_zdp200_00_000.

The ZDP200 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

Inclusion Information

Use the button on the device.

Exclusion Information

Use Habmin or another zwave tool to exclude the device from the zwave mesh.

Channels

The following table summarises the channels available for the ZDP200 -:

Channel Channel Id Category Item Type
Dimmer Switch switch_dimmer DimmableLight Dimmer

Dimmer Switch

The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.

The switch_dimmer channel supports the Dimmer item and is in the DimmableLight category.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The ZDP200 supports 1 association group.

Group 1: Dimmer Switch

This group supports 16 nodes.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_SWITCH_MULTILEVEL_V1 Linked to BASIC
COMMAND_CLASS_SWITCH_ALL_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V0  
COMMAND_CLASS_PROTECTION_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.