The openHAB Documentation Has Moved

The documentation has moved to and

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

ZRP200 HomePro Applicance Module ZRP200

This describes the Z-Wave device ZRP200, manufactured by ACT - Advanced Control Technologies with the thing type UID of act_zrp200_00_000.

The ZRP200 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.


This is a very old appliance module, which doesn’t report the manufacturer information. You’ll have to edit the node.xml file(s) yourself. Change the manufacturer from 0x7fffffff to 0x1, to set it to manufacturer ACT. Also, change the deviceType to 7fff and the deviceid to 7fff.

Inclusion Information

Use the button on the device.

Exclusion Information

Use Habmin or another zwave tool to exclude the device from the zwave mesh.


The following table summarises the channels available for the ZRP200 -:

Channel Channel Id Category Item Type
Switch switch_binary Switch Switch


Switch the power on and off.

The switch_binary channel supports the Switch item and is in the Switch category.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The device does not support associations.

Technical Information


Endpoint 0

Command Class Comment

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.