powerSwitch Power Switch EU

This describes the Z-Wave device powerSwitch, manufactured by BeNext with the thing type UID of benext_powerswitch_00_000.

Power Switch EU

Channels

The following table summarises the channels available for the powerSwitch Power Switch EU.

Channel Channel Id Channel Type UID Category Item Type
Switch switch_binary switch_binary Switch Switch

Device Configuration

The following table provides a summary of the configuration parameters available in the powerSwitch Power Switch EU. Detailed information on each parameter can be found below.

Parameter Description
1: Set to Default Set all configuration values to default values (factory settings)
4: Start up with last known socket status state in what the switch is when power is supplied
9: Relay delay time When the relay is switched it can’t be switched again until the configured time has passed
10: Led indicator Show the led compared to the relay state
1: Group 1  

1: Set to Default

Set all configuration values to default values (factory settings)

Overview

All values (0x00 – 0xFF) except for 0x55 can be used to default all the configuration params .

Property Value
Configuration ID config_1_1
Data Type INTEGER
Range 0 to 255
Default Value 0

4: Start up with last known socket status

state in what the switch is when power is supplied

Overview

If 0x01–0xFF: When power applied socket is the state before power was disconnected

Property Value
Configuration ID config_4_1
Data Type INTEGER
Range 0 to 255
Default Value 0

9: Relay delay time

When the relay is switched it can’t be switched again until the configured time has passed

Overview

Value * 10 milliseconds

Property Value
Configuration ID config_9_1
Data Type INTEGER
Range 0 to 255
Default Value 0

10: Led indicator

Show the led compared to the relay state

Overview

If value is 0: the indicator led is never switched on If value is 1: the indicator led is switched on when relay is switched on If value is 2: the indicator led is switched on when relay is switched off

Property Value
Configuration ID config_10_1
Data Type INTEGER
Range 0 to 2
Default Value 1

1: Group 1

Property Value
Configuration ID group_1
Data Type TEXT
Range to

Did you spot an error in the above definition or want to improve the content? You can edit the database here.