The openHAB Documentation Has Moved

The documentation has moved to and

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

DTHERMZ6 Living Connect Z Thermostat

This describes the Z-Wave device DTHERMZ6, manufactured by Danfoss with the thing type UID of danfoss_dthermz6_00_000.

DTHERMZ6 product image

The DTHERMZ6 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is unable to participate in the routing of data from other devices.

The DTHERMZ6 does not permanently listen for messages sent from the controller - it will periodically wake up automatically to check if the controller has messages to send, but will sleep most of the time to conserve battery life. The wakeup period can be configured in the user interface - it is advisable not to make this too short as it will impact battery life - a reasonable compromise is 1 hour. The wakeup period does not impact the devices ability to report events or sensor data. The device can be manually woken with a button press on the device as described below - note that triggering a device to send an event is not the same as a wakeup notification, and this will not allow the controller to communicate with the device.


No device information is provided in the database. Consider updating the database to improve the documentation.


The following table summarises the channels available for the DTHERMZ6 -:

Channel Channel Id Category Item Type
Sensor (temperature) sensor_temperature Temperature Number
Setpoint (heating) thermostat_setpoint Temperature Number
Battery Level battery-level Battery Number
Clock Time Offset time_offset Temperature Number

Sensor (temperature)

Indicates the current temperature.

The sensor_temperature channel supports the Number item and is in the Temperature category. This is a read only channel so will only be updated following state changes from the device.

Setpoint (heating)

Sets the thermostate setpoint.

The thermostat_setpoint channel supports the Number item and is in the Temperature category.

Battery Level

Represents the battery level as a percentage (0-100%). Bindings for things supporting battery level in a different format (e.g. 4 levels) should convert to a percentage to provide a consistent battery level reading.

The battery-level channel supports the Number item and is in the Battery category.

Clock Time Offset

Provides the current time difference for the devices time.

The time_offset channel supports the Number item and is in the Temperature category.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The DTHERMZ6 supports 1 association group.

Group 1: Target for Wakeup and Override Notifications

This group supports 1 nodes.

Technical Information


Endpoint 0

Command Class Comment

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.