PIR Z-Wave PIR Motion Sensor

This describes the Z-Wave device PIR, manufactured by Ecolink with the thing type UID of eco_pir1_00_000.

Z-Wave PIR Motion Sensor

Overview

The sensor has two Association groups available for up to five Z-Wave Node IDs each.
Association group one is intended for but not limited to controllers. All nodes whose Node ID
that have been set in Association group one will receive all unsolicited Alarm Report frames,
and Basic Report frames of 0x00 and 0xFF. Association group two is intended for any device

that is controllable with a Basic Set of 0xFF such as lights, sirens, or chimes.
When a sensor such as a door or window sensor is opened/faulted, the sensor will send a Basic
Report to nodes in Association group one and a Basic Set of 0xFF to Association group two.
When the door or window is closed the sensor will send a Basic Report of 0x00 to only group
one. The Configuration command class can configure the sensor to send Basic Sets of 0x00 to
nodes in group two (turning devices off). See Configuration Command Class.

Wakeup Information

By default, a sensor is configured to send Wake Up Notification frames every three hours. A
controller may change the duration between Wake Up Notification frames to be between one
hour and one week in increments of two hundred seconds with the Wake Up Interval Set
command. The sensor will send Wake Up Notification frames to the Node ID specified in the
Wake Up Set Interval command or 255 if no valid nodes have been set.

Channels

The following table summarises the channels available for the PIR Z-Wave PIR Motion Sensor.

Channel Channel Id Channel Type UID Category Item Type
Binary Sensor sensor_door sensor_door Door Contact
Alarm alarm_general alarm_general Door Switch
  battery-level system.battery-level    

Device Configuration

The following table provides a summary of the configuration parameters available in the PIR Z-Wave PIR Motion Sensor. Detailed information on each parameter can be found below.

Parameter Description
99: Toggle sending clear message to group 2 Toggle sending clear message to group 2
1: Group 1  
2: Group 2  

99: Toggle sending clear message to group 2

Toggle sending clear message to group 2

Overview

Set to 0 to disable sending a fault clear message (00) to group 2 when the device has cleared.

The Configuration command class can be utilized to enable Basic Sets of 0x00 on a fault
restore to nodes in Group 2 with a Configuration Set command of Parameter number 0x63
(decimal 99), a size of 1, and a Configuration value of 0xFF (decimal 255). Changing the
configuration value to 0 disables the feature.

Property Value      
Configuration ID config_99_1      
Data Type INTEGER   Default Value 0
Options Disable sending clear message (0)      
  Send clear message to group 2 (1)      

1: Group 1

Property Value
Configuration ID group_1
Data Type TEXT
Range to

2: Group 2

Property Value
Configuration ID group_2
Data Type TEXT
Range to

Did you spot an error in the above definition or want to improve the content? You can edit the database here.