GR-105N Z-Wave Motor for water/gas ball valves
This describes the Z-Wave device GR-105N, manufactured by EcoNet Controls with the thing type UID of
The GR-105N supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.
This valve clamps onto your existing valve, allowing you to open/close the valve via Z-Wave as soon as you notice a problem.
With controller in inclusion mode, triple-press valve button within 1 second to include.
With controller in exclusion mode, triple-press valve button within 1 second to exclude.
Holding the valve button for more than 10 seconds resets to factory default settings.
The following table summarises the channels available for the GR-105N -:
|Channel||Channel Id||Category||Item Type|
Switch the power on and off.
switch_binary channel supports the
Switch item and is in the
The device has no configuration parameters configured.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The GR-105N supports 1 association group.
Group 1: Group1
This group supports 5 nodes.
|COMMAND_CLASS_SWITCH_BINARY_V1||Linked to BASIC|
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.