The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

HAC01 In-Wall Remote Insert

This describes the Z-Wave device HAC01, manufactured by Everspring with the thing type UID of everspring_hac01_00_000.

The HAC01 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

No device information is provided in the database. Consider updating the database to improve the documentation.

Channels

The following table summarises the channels available for the HAC01 -:

Channel Channel Id Category Item Type
Switch switch_binary Switch Switch

Switch

Switch the power on and off.

The switch_binary channel supports the Switch item and is in the Switch category.

Device Configuration

The following table provides a summary of the 2 configuration parameters available in the HAC01. Detailed information on each parameter can be found in the sections below.

Param Name Description
1 Basic Set Level The Basic Set Command is sent with this value.
2 Amount Of Delay Amount Of Delay (seconds) to send the Basic Set Off command.

Parameter 1: Basic Set Level

The Basic Set Command is sent with this value. The Basic Set Command is sent with value to have the receiving device recognize the value for controlled level, for example, if the Basic Set Command sent to dimmer with value, the dimmer would activate the luminance according to the value.

0 : Off
1 – 99 : On (for Binary Switch Device); Dim Level (for Multilevel Switch Device) Values in the range 0 to 99 may be set.

The manufacturer defined default value is 99.

This parameter has the configuration ID config_1_1 and is of type INTEGER.

Parameter 2: Amount Of Delay

Amount Of Delay (seconds) to send the Basic Set Off command. This is applied to determine the delay time setting to send the Basic Set Off command when the manual switch input at NO (open).

Example :
0 : immediately Off
1 – 127 : delay 1 ~ 127 second to Off Values in the range 0 to 127 may be set.

The manufacturer defined default value is 1.

This parameter has the configuration ID config_2_1 and is of type INTEGER.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The HAC01 supports 1 association group.

Group 1: Switch Input Change

Target nodes that receive Basic Set command when the switch input changed. This group supports 5 nodes.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_APPLICATION_STATUS_V0  
COMMAND_CLASS_SWITCH_BINARY_V1 Linked to BASIC
COMMAND_CLASS_CONFIGURATION_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_ASSOCIATION_V1  
COMMAND_CLASS_VERSION_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.