SF812 Smoke Sensor
This describes the Z-Wave device SF812, manufactured by Everspring with the thing type UID of
The photoelectric Smoke Detector is a Z-WaveTM enabled device which is fully
compatible with any Z-WaveTM enabled network. Z-WaveTM enabled devices
displaying the Z-WaveTM logo can also be used with it regardless of the
manufacturer, and ours can also be used in other manufacturer’s Z-WaveTM
enabled networks. Inclusion of this detector on other manufacturer’s Wireless
Controller menu allows remote operation of connected modules when the
detector is triggered.
The detector is designed to sense smoke that comes into the detector chamber.
It does not sense gas, heat, or flame. The working principle is when the smoke
detector detects a certain density of smoke, the horn of smoke detector will
sound and in the meantime, the detector will emit the signals to the associated
devices for further execution. It can provide precious time for you and your
family to escape before a fire spreads.
Pressing link key three times within 1.5 second will enter inclusion mode. The Detector will stay “awake” for 10 minutes to allow time for setting and device status enquiring.
Pressing link key three times within 1.5 second will enter exclusion mode. The Detector will stay “awake” for 10 minutes to allow time for setting and device status enquiring.
The following table summarises the channels available for the SF812 Smoke Sensor.
|Channel||Channel Id||Channel Type UID||Category||Item Type|
|Alarm (Low battery)||alarm_battery||alarm_battery||Switch|
The following table provides a summary of the configuration parameters available in the SF812 Smoke Sensor. Detailed information on each parameter can be found below.
|1: Alarm notifications|
1: Alarm notifications
Did you spot an error in the above definition or want to improve the content? You can edit the database here.