GE 28167 (ZW3104) Plug-In Smart Dimmer
This describes the Z-Wave device GE 28167 (ZW3104), manufactured by Jasco Products with the thing type UID of
The GE 28167 (ZW3104) does not permanently listen for messages sent from the controller - it will periodically wake up automatically to check if the controller has messages to send, but will sleep most of the time to conserve battery life. The wakeup period can be configured in the user interface - it is advisable not to make this too short as it will impact battery life - a reasonable compromise is 1 hour. The wakeup period does not impact the devices ability to report events or sensor data. The device can be manually woken with a button press on the device as described below - note that triggering a device to send an event is not the same as a wakeup notification, and this will not allow the controller to communicate with the device.
No device information is provided in the database. Consider updating the database to improve the documentation.
The following table summarises the channels available for the GE 28167 (ZW3104) -:
|Channel||Channel Id||Category||Item Type|
The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.
switch_dimmer channel supports the
Dimmer item and is in the
Triggers when a scene button is pressed.
scene_number channel supports the
The device has no configuration parameters configured.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The device does not support associations.
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.