12727 GE 12727 Z-Wave Wireless Lighting Control Smart Toggle Switch

This describes the Z-Wave device 12727, manufactured by Jasco Products with the thing type UID of ge_12727_00_000.

GE 12727 Z-Wave Wireless Lighting Control Smart Toggle Switch

Inclusion Information

  1. Follow the instructions for your Z-wave certified controller to include a device to the Z-wave network.

  2. Once the controller is ready to include your device, press up and release the toggle switch to include it in the network.

Note: Your controller may need to be within 10 feet of the device to be included.

  1. Once your controller has confirmed that the device has been included, refresh the Z-wave network to optimize performance.

Channels

The following table summarises the channels available for the 12727 GE 12727 Z-Wave Wireless Lighting Control Smart Toggle Switch.

Channel Channel Id Channel Type UID Category Item Type
Switch switch_binary switch_binary Switch Switch

Device Configuration

The following table provides a summary of the configuration parameters available in the 12727 GE 12727 Z-Wave Wireless Lighting Control Smart Toggle Switch. Detailed information on each parameter can be found below.

Parameter Description
4: Invert switch Invert switch
29: Load Sensing  

4: Invert switch

Invert switch

Overview

If the switch is accidentally installed upside down with “On” at the bottom and “Off” at the top, the default On/Off rocker settings can be reversed by changing parameter 4’s value to “1”.

Property Value      
Configuration ID config_4_1      
Data Type INTEGER   Default Value 0
Options Normal switch install (0)      
  Inverted switch (1)      

29: Load Sensing

Overview

Load Sensing Load sensing is disabled when shipped from the factory. This feature can be enabled if desired. Setting parameter 29 to a value of 1 will enable the Load Sense function

Property Value
Configuration ID config_29_1
Data Type INTEGER
Range 0 to 1
Default Value 0

Did you spot an error in the above definition or want to improve the content? You can edit the database here.