RSZ1 Somfy Motorized Shade
This describes the Z-Wave device RSZ1, manufactured by Graber with the thing type UID of
The RSZ1 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is unable to participate in the routing of data from other devices.
No device information is provided in the database. Consider updating the database to improve the documentation.
The following table summarises the channels available for the RSZ1 -:
|Channel||Channel Id||Category||Item Type|
Switch the power on and off.
switch_binary channel supports the
Switch item and is in the
UP, DOWN, STOP
Provides start / stop control of blinds.
blinds_control channel supports the
Rollershutter item and is in the
The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.
switch_dimmer channel supports the
Dimmer item and is in the
Represents the battery level as a percentage (0-100%). Bindings for things supporting battery level in a different format (e.g. 4 levels) should convert to a percentage to provide a consistent battery level reading.
battery-level channel supports the
Number item and is in the
The device has no configuration parameters configured.
Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.
The RSZ1 supports 1 association group.
Group 1: Primary
Lifeline (primary controller) This group supports 1 nodes.
Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.