The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

HA-01C In-Wall Dual Receptacle

This describes the Z-Wave device HA-01C, manufactured by Intermatic with the thing type UID of intermatic_ha01c_00_000.

The HA-01C supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

The Intermatic HA01C Wall Receptacle is an in­-wall Z-­Wave switch that can be controlled to automatically and wirelessly to replace an existing receptacle to control lamps, or small appliances. It also works as a range extender for your other Z-­Wave devices. This In-Wall receptacle features two plug receptacles, both of which provide standard power operation, only the bottom plug in the outlet is controllable by Z-Wave. Ratings: 15 A, 125 VAC, 50/60 Hz Operating Temperature Range: 32°F to 104°F / 0°C to 40°C Radio Operating Frequency: 908.42 MHz RF (wireless) Range: 50-100 ft. under normal operating conditions

Inclusion Information

After hard-wiring the HA01 into place, the device is ready to join your Z-Wave™ network.

NOTE: Before you begin, devices (such as lamps) should be plugged in and turned ON before including the HA01 in your network. Put the controller into INCLUSION mode. Press the ON/OFF/PROGRAM button on the HA01 In-Wall Receptacle.

Exclusion Information

If necessary, you can delete the HA01 In-Wall Receptacle from your Z-Wave™ network. Put the controller into EXCLUSION mode. Press the ON/OFF/PROGRAM button on the HA01 In-Wall Receptacle.

Channels

The following table summarises the channels available for the HA-01C -:

Channel Channel Id Category Item Type
Switch switch_binary Switch Switch

Switch

Switch the power on and off.

The switch_binary channel supports the Switch item and is in the Switch category.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The device does not support associations.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_SWITCH_BINARY_V1 Linked to BASIC
COMMAND_CLASS_SWITCH_ALL_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_VERSION_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.