IM-20 Door Sensor
This describes the Z-Wave device IM-20, manufactured by Kaipule Technology Co., Ltd. with the thing type UID of
Press the tamper switch 6 times in 2s, it will recover to factory setting after a period of time
(Please use the reset procedure only when the primary controller is missing or inoperable)
Enter the Inclusion Mode of gateway, and press the tamper switch 3 times within 1.5s,
then the door sensor will stay in enrollment state until successfully enrolled into network or
enrollment time out after 30s.
Enter the Exclusion Mode of gateway, and press the tamper switch 3 times within
1.5s, then the door sensor will be removed after a period of time.
a) Manual Wake-up
Quickly press tamper switch once, the door sensor will automatically send wake-up
information, and there will be 10s after wake-up to receive gateway setting information.
b) Automatic Wake-up
Default time of automatic wake-up is 24 hours, and there will be 10s after wake-up to receive
gateway setting information, the max automatic report time = 24 hours, minimum=30min
The following table summarises the channels available for the IM-20 Door Sensor.
|Channel||Channel Id||Channel Type UID||Category||Item Type|
The following table provides a summary of the configuration parameters available in the IM-20 Door Sensor. Detailed information on each parameter can be found below.
|1: Group 1|
1: Group 1
Did you spot an error in the above definition or want to improve the content? You can edit the database here.