The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

NGD00Z-4 Garage Door Controller

This describes the Z-Wave device NGD00Z-4, manufactured by Linear Corp with the thing type UID of linear_ngd00z4_00_000.

The device is in the category of Garage Door, defining Garage Door.

NGD00Z-4 product image

The NGD00Z-4 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

GARAGE DOOR OPENER REMOTE COMMAND TRANSCEIVER with TILT SENSOR

Inclusion Information

TO INCLUDE THE GD00Z-4 INTO YOUR CONTROLLER

  1. Place your Z-Wave Controller into Discovery or Include mode.
  2. Press and release the link button on the GD00Z-4.
  3. Confirm that the GD00Z-4 was recognized by your Z-Wave Controller.

Exclusion Information

TO EXCLUDE THE GD00Z-4 FROM YOUR CONTROLLER

  1. Place your Z-Wave Controller into Exclude mode.
  2. Press and release the link button on the GD00Z-4.
  3. Confirm that the GD00Z-4 was excluded by your Z-Wave Controller.

Channels

The following table summarises the channels available for the NGD00Z-4 -:

Channel Channel Id Category Item Type
Barrier State barrier_state Door Number
Alarm (raw) alarm_raw   String

Barrier State

Send 0 to CLOSE the Garage Door

Send 255 to OPEN the Garage Door

Reading this value provides the Status of the Garage Door. Status values are:

0 = Closed

252 = Closing

253 = Stopped

254 = Opening

255 = Open

Indicates the state of the barrier.

The barrier_state channel supports the Number item and is in the Door category. This is a read only channel so will only be updated following state changes from the device.

The following state translation is provided for this channel to the Number item type -:

Value Label
0 Closed
252 Closing
253 Stopped
254 Opening
255 Open

Alarm (raw)

Provides the raw alarm status information as a string, including alarm type and level, in the following json format:

{“type”:”ACCESS_CONTROL”,”event”:”6”,”status”:”255”}

Provides alarm parameters as json string.

The alarm_raw channel supports the String item. This is a read only channel so will only be updated following state changes from the device.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The NGD00Z-4 supports 1 association group.

Group 1: Group 1

This group supports 1 nodes.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_APPLICATION_STATUS_V0  
COMMAND_CLASS_DEVICE_RESET_LOCALLY_V1  
COMMAND_CLASS_BARRIER_OPERATOR_V1  
COMMAND_CLASS_ALARM_V3  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_ASSOCIATION_V1  
COMMAND_CLASS_VERSION_V1  
COMMAND_CLASS_SECURITY_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.