The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

507601 Dual Pole Wall Switch

This describes the Z-Wave device 507601, manufactured by Merten with the thing type UID of merten_507601_00_000.

The device is in the category of Wall Switch, defining Any device attached to the wall that controls a binary status of something, for ex. a light switch.

The 507601 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

No device information is provided in the database. Consider updating the database to improve the documentation.

Channels

The following table summarises the channels available for the 507601 -:

Channel Channel Id Category Item Type
Switch switch_binary Switch Switch

Switch

Switch the power on and off.

The switch_binary channel supports the Switch item and is in the Switch category.

Device Configuration

The following table provides a summary of the 3 configuration parameters available in the 507601. Detailed information on each parameter can be found in the sections below.

Param Name Description
176 Staircase timer byte 1  
177 Staircase timer byte 2  
183 Additional limit duration (after brief interruption) Unsure what this does

Parameter 176: Staircase timer byte 1

Values in the range 0 to 127 may be set.

The manufacturer defined default value is 0.

This parameter has the configuration ID config_176_1 and is of type INTEGER.

Parameter 177: Staircase timer byte 2

Values in the range 0 to 127 may be set.

The manufacturer defined default value is 0.

This parameter has the configuration ID config_177_1 and is of type INTEGER.

Parameter 183: Additional limit duration (after brief interruption)

Unsure what this does

Values in the range 0 to 127 may be set.

The manufacturer defined default value is 30.

This parameter has the configuration ID config_183_1 and is of type INTEGER.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The 507601 supports 1 association group.

Group 1: Group 1

This group supports 5 nodes.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_SWITCH_BINARY_V0 Linked to BASIC

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.