The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

507801 CONNECT radio flush-mounted receiver, Roller shutter

This describes the Z-Wave device 507801, manufactured by Merten with the thing type UID of merten_507801_00_000.

The device is in the category of Blinds, defining Roller shutters, window blinds, etc..

507801 product image

The 507801 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

Inclusion Information

Learn mode (for integration into Z-wave systems from other manufacturers):

Triple click on the switch button within 1.5s

see also http://www.merten.de/uploads/tx_seqdownload/V5078_581_00_web.pdf

Exclusion Information

1)

Press the switch button three times in quick succession (within approx 1.5 seconds) (Figure ! B; using an insulated tool such as an insulated phase tester.

The LED (Figure !A) flashes at intervals of one second.

2)

Then press and hold the switch button until the LED stops flashing (approx. 5 seconds).

The device has now been reset to its factory settings

see also http://www.merten.de/uploads/tx_seqdownload/V5078_581_00_web.pdf

Channels

The following table summarises the channels available for the 507801 -:

Channel Channel Id Category Item Type
Blinds Control blinds_control1 Blinds Rollershutter

Blinds Control

Provides start / stop control of blinds.

The blinds_control1 channel supports the Rollershutter item and is in the Blinds category.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The device does not support associations.

Technical Information

Endpoints

Endpoint 0

| Command Class | Comment | |—————|———| | COMMAND_CLASS_NO_OPERATION_V1| | | COMMAND_CLASS_BASIC_V1| | | COMMAND_CLASS_SWITCH_MULTILEVEL_V1| | | COMMAND_CLASS_BASIC_WINDOW_COVERING_V1| | | COMMAND_CLASS_MULTI_CHANNEL_V2| | | COMMAND_CLASS_CONFIGURATION_V1| | | COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1| | | COMMAND_CLASS_PROTECTION_V2| | | COMMAND_CLASS_ASSOCIATION_V1| | | COMMAND_CLASS_VERSION_V1| |

Endpoint 1

| Command Class | Comment | |—————|———| | COMMAND_CLASS_BASIC_V0| | | COMMAND_CLASS_SWITCH_MULTILEVEL_V1| Linked to BASIC| | COMMAND_CLASS_BASIC_WINDOW_COVERING_V1| | | COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1| | | COMMAND_CLASS_PROTECTION_V2| | | COMMAND_CLASS_VERSION_V1| |

Endpoint 2

Command Class Comment
COMMAND_CLASS_BASIC_V0  
COMMAND_CLASS_SWITCH_MULTILEVEL_V1 Linked to BASIC
COMMAND_CLASS_BASIC_WINDOW_COVERING_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_PROTECTION_V2  
COMMAND_CLASS_VERSION_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.