The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

FT121 LED RGBWW Strip

This describes the Z-Wave device FT121, manufactured by Fantem with the thing type UID of oomi_ft121_00_000.

The device is in the category of Light Bulb, defining Devices that illuminate something, such as bulbs, etc..

FT121 product image

The FT121 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

The LED Strip is a multi-colored LED Strip which allows control of color temperature (warm/cold white), RGB, and dimming via Z-Wave commands.

Inclusion Information

Set your Z-Wave controller into pairing mode. Press the Action Button located on the back of the LED Strip’s white controller box once (The network LED will blink green as an indication it is pairing insecurely, please refer to section “Enabling Security Encryption” in the Advanced Function section of the manual to pair it securely). If the LED Strip has been successfully added to your Z-Wave network, its Network LED will become solid. If the pairing was unsuccessful, the red LED will be on for 2 seconds and then remain a colorful gradient, repeat the instructions above from step 1.

Exclusion Information

Set your Z-Wave controller into device removal mode. Press the Action Button located on the back of the LED Strip’s white controller box once. If the LED Strip has been successfully removed from your Z-Wave network, its Network LED will remain colorful gradient. If the removal was unsuccessful, the Network LED will still be solid, repeat the instructions above from step 1.

Channels

The following table summarises the channels available for the FT121 -:

Channel Channel Id Category Item Type
Dimmer switch_dimmer DimmableLight Dimmer
Color Control color_color   Color
Color Temperature color_temperature ColorLight Dimmer

Dimmer

The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.

The switch_dimmer channel supports the Dimmer item and is in the DimmableLight category.

Color Control

The color channel allows to control the color of a light. It is also possible to dim values and switch the light on and off.

The color_color channel supports the Color item.

Color Temperature

The color temperature channel allows to set the color temperature of a light from 0 (cold) to 100 (warm).

The color_temperature channel supports the Dimmer item and is in the ColorLight category.

Device Configuration

The device has no configuration parameters configured.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The device does not support associations.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_SWITCH_MULTILEVEL_V1 Linked to BASIC
COMMAND_CLASS_SWITCH_COLOR_V1  
COMMAND_CLASS_CONFIGURATION_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.