ZW ESJ 300 Duwi ZW ESJ 300 Blind Control

This describes the Z-Wave device ZW ESJ 300, manufactured by Reitz-Group.de with the thing type UID of reitz_zwesj300_00_000.

Duwi ZW ESJ 300 Blind Control

Channels

The following table summarises the channels available for the ZW ESJ 300 Duwi ZW ESJ 300 Blind Control.

Channel Channel Id Channel Type UID Category Item Type
Switch switch_binary switch_binary Switch Switch
Blinds Control blinds_control blinds_control Blinds Rollershutter

Blinds Control

Invert control

Invert the blinds control

Property Value      
Configuration ID config_invert_control      
Data Type BOOLEAN   Default Value false
Options Yes (true)      
  No (false)      

Invert percentage value

Invert the blinds percentage value

Property Value      
Configuration ID config_invert_percent      
Data Type BOOLEAN   Default Value false
Options Yes (true)      
  No (false)      

Step duration

Sets the dim rate speed
Values from 1 to 127 are defined in seconds, while values from 128 to 254 are defined in minutes.

Property Value      
Configuration ID config_duration      
Data Type INTEGER      
Range 1 to 254   Default Value 255
Options Device Default (255)      
  Change Instantly (0)      

Device Configuration

The following table provides a summary of the configuration parameters available in the ZW ESJ 300 Duwi ZW ESJ 300 Blind Control. Detailed information on each parameter can be found below.

Parameter Description
0: Running time Adjustment of the operating times of the sun blind control
1: Stop-functionality Adjusting the Stop-Functionality

0: Running time

Adjustment of the operating times of the sun blind control

Overview

NOTE: The set values remain stored even after a power failure. The adjustment process of the operating times can be repeated anytime.
NOTE: Should the adjustment of the operating times take place with the help of the configuration tool of a third-party manufacturer, you can consider the following values as the basis: Please note that the adjustments should be undertaken only by well-versed technicians.

0x00 = nointerruption/permanent operation

0x01-0x7F = 1 second to 127 seconds in 1-second steps

0x80-0xFE = 130 seconds (0x80) to 1390 seconds (0xFE) in 10 second-steps

0xFF = factory settings 120 seconds

Property Value
Configuration ID config_0_1
Data Type INTEGER
Range 0 to 255
Default Value 0

1: Stop-functionality

Adjusting the Stop-Functionality

Overview

5.2.2 ADJUSTING THE STOP-FUNCTIONALITY:

You can also programm the shutter actuator in a way, that in case of a press in the apposite direction, the shutter won‘t stop, but continue directly in the opposite way (Z-Wave conform). Please proceed as follows:

  • Hold the “UP” and “DOWN” button of the shutter actuator simulaneausly for 5 seconds. Please note, that the devise nust not be included in the network!
  • Alternatively by configuration command (only for adviced users): Set the configuration value “1” to the value “0” in or- der to disable the stop-functionality.

    In order to enable the stop-functionality, please proceed as follows:

  • Hold the “UP” and “DOWN” button of the shutter actuator simulaneausly for 5 seconds. Please note, that the devise

    nust not be included in the network!

  • Alternatively by configuration command (only for adviced users): Set the configuration value “1” to the value “1” in order

    to enable the stop-functionality. 

Property Value      
Configuration ID config_1_1      
Data Type INTEGER   Default Value 1
Options Disabled (0)      
  Enabled (default) (1)      

Did you spot an error in the above definition or want to improve the content? You can edit the database here.