TZ36D Dual Paddle Wall Switch

This describes the Z-Wave device TZ36D, manufactured by TKB Home with the thing type UID of tkb_tz36d_02_001.

Dual Paddle Wall Switch

Inclusion Information

Note: This module must be “Included in the Network” only where it will be permanently installed. The proper operation of this node in the mesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” configure this module and the install it.

Channels

The following table summarises the channels available for the TZ36D Dual Paddle Wall Switch.

Channel Channel Id Channel Type UID Category Item Type
Switch switch_binary switch_binary Switch Switch
Scene Number scene_number scene_number   Number

Device Configuration

The following table provides a summary of the configuration parameters available in the TZ36D Dual Paddle Wall Switch. Detailed information on each parameter can be found below.

Parameter Description
1: Night light LED behaviour control.
2: Memory function Memory function behaviour control.
3: Invert switch Swap top and bottom switch/button.
4: LED transmission indication Tranmission indication behaviour control.
5: Suspend group 4 Group 4 command sending behaviour control.
1: Lifeline  
2: On/Off Dimmer 1 Use the Left Switch to control a group
3: On/Off Dimmer 2  
4: wireless  

1: Night light

LED behaviour control.

Overview

From the manual: The LED on the switch will by default, turn ON when the load attached is turned OFF. To make the LED turn ON when the attached load is turned ON, set the parameter 1 to a value of 1.

Property Value      
Configuration ID config_1_1      
Data Type INTEGER   Default Value 1
Options Switch off = LED off (0)      
  Switch off = LED on (1)      

2: Memory function

Memory function behaviour control.

Overview

From the manual: Default value is 1, when the value is 0, switch memory function not open; when the value is 1, open switch memory function.

Property Value      
Configuration ID config_2_1      
Data Type INTEGER   Default Value 1
Options Memory function off (0)      
  Memory function on (1)      

3: Invert switch

Swap top and bottom switch/button.

Overview

To switch top and bottom switch, set this parameter to 1.

Property Value      
Configuration ID config_3_1      
Data Type INTEGER   Default Value 0
Options Normal behaviour. (0)      
  Switch top and buttom button. (1)      

4: LED transmission indication

Tranmission indication behaviour control.

Overview

This parameter controls the LED behaviour when transmitting data to any of the group members.

Property Value      
Configuration ID config_4_1      
Data Type INTEGER   Default Value 1
Options Do not flicker. (0)      
  Flicker for 1 second at the beginning of transmission. (1)      
  Flicker entire time when transmitting. (2)      

5: Suspend group 4

Group 4 command sending behaviour control.

Overview

Disable transmitting commands to Group 4.

Property Value      
Configuration ID config_5_1      
Data Type INTEGER   Default Value 0
Options Sending commands to Group 4 is enabled. (0)      
  Do not sen commands to Group 4. (1)      

1: Lifeline

Property Value
Configuration ID group_1
Data Type TEXT
Range to

2: On/Off Dimmer 1

Use the Left Switch to control a group

Property Value
Configuration ID group_2
Data Type TEXT
Range to

3: On/Off Dimmer 2

Property Value
Configuration ID group_3
Data Type TEXT
Range to

4: wireless

Property Value
Configuration ID group_4
Data Type TEXT
Range to

Did you spot an error in the above definition or want to improve the content? You can edit the database here.