The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

WiDom Universal Relay Switch WiDom Universal Relay Switch

This describes the Z-Wave device WiDom Universal Relay Switch, manufactured by wiDom with the thing type UID of widom_ubs_01_000. This version of the device is limited to firmware version 1.0

The WiDom Universal Relay Switch supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

No device information is provided in the database. Consider updating the database to improve the documentation.

Channels

The following table summarises the channels available for the WiDom Universal Relay Switch -:

Channel Channel Id Category Item Type
Switch switch_binary Switch Switch

Switch

Switch the power on and off.

The switch_binary channel supports the Switch item and is in the Switch category.

Device Configuration

The following table provides a summary of the 2 configuration parameters available in the WiDom Universal Relay Switch. Detailed information on each parameter can be found in the sections below.

Param Name Description
1 Device status 1 click Device status when the external switch receives 1 click
2 Device status 2 click  
  Switch All Mode Set the mode for the switch when receiving SWITCH ALL commands

Parameter 1: Device status 1 click

Device status when the external switch receives 1 click

The following option values may be configured -:

Value Description
1 TOGGLE
2 ON
3 OFF
4 IGNORE

The manufacturer defined default value is 1 (TOGGLE).

This parameter has the configuration ID config_1_1 and is of type INTEGER.

Parameter 2: Device status 2 click

Device status when the external switch receives 2 click The following option values may be configured -:

Value Description
1 TOGGLE
2 ON
3 OFF
4 IGNORE

The manufacturer defined default value is 1 (TOGGLE).

This parameter has the configuration ID config_2_1 and is of type INTEGER.

Switch All Mode

Set the mode for the switch when receiving SWITCH ALL commands.

The following option values may be configured -: | Value | Description | |——–|————-| | 0 | Exclude from All On and All Off groups | | 1 | Include in All On group | | 2 | Include in All Off group | | 255 | Include in All On and All Off groups |

This parameter has the configuration ID switchall_mode and is of type INTEGER.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The WiDom Universal Relay Switch supports 5 association groups.

Group 1: Group 1

This group supports 16 nodes.

Group 2: Group 2

This group supports 16 nodes.

Group 3: Group 3

This group supports 16 nodes.

Group 4: Group 4

This group supports 16 nodes.

Group 5: Group 5

This group supports 16 nodes.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_SWITCH_BINARY_V1 Linked to BASIC
COMMAND_CLASS_SWITCH_ALL_V1  
COMMAND_CLASS_CONFIGURATION_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_NODE_NAMING_V1  
COMMAND_CLASS_ASSOCIATION_V1  
COMMAND_CLASS_VERSION_V1  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.