The openHAB Documentation Has Moved

The documentation has moved to openhab.org/docs and openhab.org/addons.

Please use the link below to be redirected to the new version of this article, and update your bookmarks.

RGBWE2 RGBW Bulb V2

This describes the Z-Wave device RGBWE2, manufactured by Zipato with the thing type UID of zipato_bulb2rgbw_00_000.

The device is in the category of Light Bulb, defining Devices that illuminate something, such as bulbs, etc..

RGBWE2 product image

The RGBWE2 supports routing. This allows the device to communicate using other routing enabled devices as intermediate routers. This device is also able to participate in the routing of data from other devices.

Overview

No device information is provided in the database. Consider updating the database to improve the documentation.

Channels

The following table summarises the channels available for the RGBWE2 -:

Channel Channel Id Category Item Type
Dimmer switch_dimmer DimmableLight Dimmer
Color Control color_color   Color
Color Temperature color_temperature ColorLight Dimmer

Dimmer

The brightness channel allows to control the brightness of a light. It is also possible to switch the light on and off.

The switch_dimmer channel supports the Dimmer item and is in the DimmableLight category.

Color Control

The color channel allows to control the color of a light. It is also possible to dim values and switch the light on and off.

The color_color channel supports the Color item.

Color Temperature

The color temperature channel allows to set the color temperature of a light from 0 (cold) to 100 (warm).

The color_temperature channel supports the Dimmer item and is in the ColorLight category.

Device Configuration

The following table provides a summary of the 1 configuration parameters available in the RGBWE2. Detailed information on each parameter can be found in the sections below.

Param Name Description
1 Internal bulb temperature  
  Switch All Mode Set the mode for the switch when receiving SWITCH ALL commands

Parameter 1: Internal bulb temperature

Values in the range 0 to 0 may be set.

The manufacturer defined default value is 0.

This parameter has the configuration ID config_1_1 and is of type INTEGER. This is a read only parameter.

Switch All Mode

Set the mode for the switch when receiving SWITCH ALL commands.

The following option values may be configured -: | Value | Description | |——–|————-| | 0 | Exclude from All On and All Off groups | | 1 | Include in All On group | | 2 | Include in All Off group | | 255 | Include in All On and All Off groups |

This parameter has the configuration ID switchall_mode and is of type INTEGER.

Association Groups

Association groups allow the device to send unsolicited reports to the controller, or other devices in the network. Using association groups can allow you to eliminate polling, providing instant feedback of a device state change without unnecessary network traffic.

The device does not support associations.

Technical Information

Endpoints

Endpoint 0

Command Class Comment
COMMAND_CLASS_NO_OPERATION_V1  
COMMAND_CLASS_BASIC_V1  
COMMAND_CLASS_SWITCH_MULTILEVEL_V2  
COMMAND_CLASS_SWITCH_ALL_V1  
COMMAND_CLASS_SWITCH_COLOR_V1  
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V1  
COMMAND_CLASS_DEVICE_RESET_LOCALLY_V1  
COMMAND_CLASS_ZWAVEPLUS_INFO_V1  
COMMAND_CLASS_CONFIGURATION_V1  
COMMAND_CLASS_MANUFACTURER_SPECIFIC_V1  
COMMAND_CLASS_POWERLEVEL_V1  
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V1  
COMMAND_CLASS_ASSOCIATION_V2  
COMMAND_CLASS_VERSION_V2  

Did you spot an error in the above definition or want to improve the content? You can contribute to the database here.